Preparation:
Make sure all turn signal lights work before beginning installation. If you have a light that’s burned out replace it because
it could be misleading later on and cause trouble shooting issues. Inside of the trunk remove rear trim panel to expose
taillight wires and retaining nuts. Remove the three 11mm nuts on each taillight, unplug each Grey plug, then remove
taillight from car, and place them on a workbench for light socket replacement.
Reason why inboard light sockets needs to be replaced is because this light functions only as a running light and so did
not have the need for the extra wire for the turn signal. By replacing the light socket we will have this wire for the turn
signal as well as the running light.
NOTE: The taillight wiring harness is the same for both Left and Right sides. Connecting the new light socket is the same
on both sides.

Category : Automotive, Ford
Source : http://www.meter4it.com
Language : English
View : 407 views
Size : 900 Kb
Date : March 11th, 2010

(No Ratings Yet)

 Loading ...