Owner’s Manual for Car Security System with Remote Engine

ARM alarm (a) The siren will chirp once and lights flash once. (b) If equipped with central lock, doors lock automatically. (C) Alarm is armed after 5 seconds, the LED flashes. B) To disarm the alarm system (a) Siren will chirp 2 times and lights Flash 3 times. (B) Power door lock / unlock automatically. (C) alarm disarmed and returns to its normal state. (D) in the automatic mode, the siren will not chrip Please also refer to “Auto re AWP” function. Anti-hijacking (1) while driving, including key positions ACC.ON and the press, parking lights will flash quickly (it stood for anti-hijacking mode). And then press the button for 5 seconds, then the system in anti-hijacking mode. Parking lights will still keep flashing, and then press again, the engine will cut off immediately and siren will keep sounding. Press to stop this function. TIPS FOR A SUCCESSFUL remote start the engine after a successful remote start engine, the direction of the light will continue flashing and siren chirp 3 times in 25 seconds, the direction of light stops flashing, until the car warms up to finish. Central locking installation diagrams. For cars with central locking, but no motor on driver side, add the Motor Master and the rod. (see Figure 2). Wire connecting CHART This type of installation is used to operate factory lock systems in some FORD, Mitsubishi, Mazda, Nissan and models. * Installation tips: First installation of the drive door manual latch, and then fix the drive shaft to guide the latch TYPE C: For vehicles equipped with central lock and with motor on the driver side. (See Figure 3) Type of work: Door locks are controlled electrically activated vacuum pump. (See Figure 4). Terms of drive mechanism can be set to 0.7 seconds or 3 seconds on JP2. For some Mercedes-Benz and Audi models.