This guide contains information about installing the Auxiliary LED brake for motor Harley Davidson. If this manual states that this product can be installed with suction cups, magnets, tape or Velcro ™, clean the mounting surface with a 50/50 mixture of alcohol, propylene and water and dry thoroughly. He recommended that these instructions be stored in a safe place and referred to when performing maintenance and / or after the installation of this product. When mounting the light head on Harley Davidson motor cycle field, using the existing holes with wire. Drill your holes such wire holes (located very close to the mounting hole in the light of the head) will line up with wires, but does not interfere with the mounting holes. Check the location of mounting holes 2 on the mounting surface using the dimensions given above, or remove the lens and use it as a template. Always check for the mounting surface to be sure that will not interfere with any other components of the vehicle. 2. Drill 2 holes using a drill size for # 6 sheet metal screw, then drill the 9 / 32 “wire access hole 5 / 16″ from mounting hole as shown.

Category : Harley Davidson
Source : http://www.whelen.com
Language : Eng
View : 518 views
Size : -
Date : November 3rd, 2009

(No Ratings Yet)

 Loading ...