Installation Instruction Guide for Harley-Davidson Electronic Ignition Module

Take time on a busy ignition model is examined. Some bikes have a wrong model ignition system mounted in respect of the year. It can be very confusing. Particularly in the year 1947, which changed time basis. Please read the installation instructions before mounting kit! Step 1: “for the position” closed ignition (main switch off lights Dashboard
Switch), Step 2: Disconnect (ground) battery cable from Step 3: negative circuit breaker breaker points and condenser Remove from time basis. Step 4: Advance Disconnect / time basis from Step 5 cable retarded: timer shaft and housing Remove from time basis (for instructions see your manual). Use two old screws flange mount aluminum is based on time. See figure 1 and 2 models and strategies appropriate for hole. Ignition coil wire to two routes. HD Service for aerial ignition Czech manual for a proper way. (Keep away from hot exhaust system surfaces like). Cut cable to length for mounting the necessary precision. Install rotor shaft campaign triggered timer, and using hex key tool tighten hex bolt. Tighten the screw is in! Remove spark plugs from the engine, put them on and engine spark wire cable connected to ground. Enables normal operation of the spark, and compression stroke engine firing prevents the unwanted. Look for Service manual or instructions booklet at the time of their model. All electronic ignition module is fully tested. A voltmeter between ignition coil terminal, where the red wire is connected and check with the ground. The terminal a 6 volt system, one for 12 or 12 volt system voltage one volt to 6 volt happen. At least batteries or wires system voltages or voltage drop indicates a main switch.