7.3 Power Stroke Engine Technician High Pressure Pump Guide

High-pressure pump with oil leaks in fittings for high pressure lines and connectors on the back can be repaired in the field using the following Ford part number 2C3Z-9G804-AA kit. This kit consists of 3 o-rings, sealant, and instructions on how to clean and close the equipment. Torque specs. for equipment is also included. Condensed from the PC / ED, a block from the right bank, attempts to start, began to show a leak on the right, reconnect the hose to the right edge, remove the right side valve cover, remove the connectors on both injector valve cover, Replace injector if the leakage of oil spills belching or o-ring if the leak is from the injector bore. If no start – leakage / loss may not be right on the head, but the ICP is still low. Blocks from the left edge and moved the ICP to the adapter. Attempt to start, began to show a leak on the left and install the ICP to the left hand, remove the left side valve cover. injector pulled the plug on the valve cover. Engine started but it has a P1211 code: IR% higher than excluded. Going long after a cold start may also be a symptom before the diagnosis of vehicles with P1211. pressire fuel to be verified. Abnormally long crank / stall after a cold start. To begin the long hard crank or no start in which injector will not be humming loudly as they cool.